NOMO GROUP CO LIMITED

We are one of the leading providers of solar LED applications in the world!

Home > News > Content
Low Operating Cost Of Split Solar Street Lamp
- Jul 28, 2017 -


Split Solar Street lamp on the battery, led lamp, photovoltaic panels, this must be equipped with light rods, batteries buried in the underground, through the lamp rod inside the wire, during the day through the photovoltaic panels to store electricity, at night to the LED lamp power supply, because the battery in the underground, easy to be stolen. and integrated solar street lamp batteries, LED lamp caps, Split Type Solar Street Light photovoltaic panels in one set to the lamp, there are no light rods can be. Now there is a deformation of the split solar street lamp, parts although also separate, but the battery will be in the Telegraph pole or installed LED lamp holder next to the lamp can be.

Split Solar Street Lamp technical parameters can be from 10-80w or even higher can be, such as: new rural Solar Street Lamp series, in the configuration, according to the number of watts, rainy day, Split Type Solar Street Light the number of different technical parameters to the corresponding configuration of batteries, PV board size, controller, etc., but also according to the actual installation to adjust the exposure angle of photovoltaic panels; Integrated Solar street lamps are now generally the number of Watts 10w, 20w, 30w, 40w several, Split Type Solar Street Light each is based on a long time the best configuration, Like 3-6 meters 20W new rural solar street lamps.

According to the technical parameters, solar street lamps are mainly used for large roads, highways and other lamps with high demand; integrated solar street lamps can be used in streets, neighborhoods, factories, rural areas, county streets, village streets and other places.

Split Solar street lamp maintenance to be a lot more complex, when there is damage, need to send technicians to the local manufacturers to repair, Split Type Solar Street Light maintenance needs from the battery, photovoltaic panels, LED lamp caps, wires and other one by one troubleshooting; Integrated Solar street lamp just to remove the lamp holder, sent back to the factory.

Split Solar Street Light

(i) Characteristics

1, the solar module is made of monocrystalline silicon and polycrystalline silicon cells.

2, solar modules are designed according to the International Electrotechnical organization IEC-61215.1993 Standard.

3, structure, positive 3.2MM high transmittance (more than 92%) of low iron tempered glass, Split Type Solar Street Light back material for TPT, plastic film for Eva.

4, frame, aluminum oxide coating.

5, including multiple waterproof contact linker.

6, the component size can be adjusted according to customer requirements.

(ii) advantages

1, low operating costs, no energy consumption.

2, easy to install, no need to lay a line and put a large number of installation costs.

3, can be used in different environments.

4, according to the actual load demand for accurate design.

5, low maintenance costs.

6, no fuel needed.

7. No noise during operation.

8, there is no easy to wear the moving parts.

9, no pollution, environmental protection.

10, can work in unattended environment for a long time.

11, the daily lighting time 6-8 hours, Split Type Solar Street Light can be 3 consecutive rainy days work.